Carrier Sequential Tendering Control: Optional. If specified, this value will supersede the corresponding value for the tariff service. When set to exclude, carrier sequential tendering will exclude the tariff service from consideration unless both carrier and service have been hard or soft committed.
Auto-Accept Tender: Optional. If specified, this value will supersede the corresponding value for the tariff service. When auto-accept tender is enabled, any tender issued will be immediately accepted.
Carrier Performance Enabled: Indicates whether the carrier performance score is enabled at the lane level. If not, rating by performance will use the carrier performance score defined for the carrier.
Carrier Performance: Optional. When rating is based on performance, the applicable carrier performance grade will be used in conjunction with relative costs for each tariff during rate shopping; if carrier performance is enabled at lane level (see separate flag), this grade will be used else the value for the carrier will apply. When rating is performed for a referential tariff, carrier performance scores for lanes configured on the master tariff will be considered only if the "Use Carrier Performance from Master Tariff Lanes" is checked for the tariff. See "Carrier Selection – Cost vs. Performance".
Optimization Control: Optional. If specified, this value will supersede the corresponding value for the tariff service. When set to exclude, optimizer will exclude the tariff service from consideration unless both the carrier and service have been hard or soft committed.
Freight Auction Eligibility: Optional. If specified, this value will supersede the corresponding value for the tariff service. This can be used to control whether this lane should be considered eligible for freight auction. If enabled for contract bidding, the corresponding carrier can be included as one of the recipients when a contract bidding round is initiated. This same applies for non-contract.